Wow! just watched three of the videos. Too complicated for me.
Wow! just watched three of the videos. Too complicated for me.
Suppose you were an idiot. And suppose you were a member of Congress. But I digress....
Jim you would be surprised. It may be more than you want to mess with but I doubt it would be over your head. Many of these videos are made by people who are just learning the stuff, and they tell you that. So consider that these people were clueless and they are doing it. You are a bit older and have a little wisdom in you.
Last edited by Archer0915; 03-05-2017 at 04:38 PM.
Okay just hooked up some 10 GA and slapped in a new breaker! Good to go.
Archer0915 (03-05-2017)
Let us know how the learning curve went and what you think after awhile.
Suppose you were an idiot. And suppose you were a member of Congress. But I digress....
Honestly, for me... I am used to this stuff and I have been messing with it for a long time. I have CNC experience on everything from lathes to water jets.
This type of machine is on the simple side and you can actually put a Corel drawing im and engrave it. As far as the actual program? It will look something like my 3d printers program but only one layer.
This new stuff works off of vector, raster or both and software converts your image to Gcode.
Actually this will be much easier than the 3D printer.
Is it possible to cut metals?
‘There is no God but Resister and Refugee is his messenger’.
Book of Democrat Things, Chapter 1:1